RUMLogNG on the Mac will turn it off automatically when connecting and then back on when exiting. The C-IV address for all IC-7300 rigs is 94 and the CI-V address for this software should be left at its defaut of E0.
Waterfall not selected in standard screen due to the limited space available (much more useful in EXPD Screen, Small Size). The speed is set to 115200 baud to allow the use of the spectrum scope on the REMOTE PC (it is disabled at slower speeds). MacLoggerDX needs it on as well as WSJT-X and FT8Call on the Mac. To use the spectrum scope with RS-BA1 : On the IC-7300: Unlink USB from REMOTE Set baud rate to 115200 Connect with USB cable. Improved 'Spectrum Scope' settings for the ICOM IC-7300. It needs to be ON for certain things to work correctly. To Unlink, tap the “Link to on the LCD, then tap Unlink from. The CI-V USB Baud Rate also needs to be 115200.
#Icom 7300 115200 scope rs ba1 serial#
use the virtual serial port on it for the digital software (WJST-X), you can set the baud to 9600 on it. USB port with a speed of up to 115,200 bps.
#Icom 7300 115200 scope rs ba1 driver#
This is for software waterfalls and spectrum scopes to work properly. Use the virtual serial port the driver the PC creates for the USB port to run the remote software (RS-BA1). When you first touch the scope screen around the intended signal, the touched part is. The IC-7300s real-time spectrum scope provides top-level performance in. While listening to received audio, you can check the real-time spectrum scope and quickly move to an intended signal. The Icom RS-BA1 IP Remote Control Software allows you to use an Icom compatible. I also use RS-BA1 sometimes and it’ll turn it back on. The IC-7300’s real-time spectrum scope is classleading in resolution, sweep speed and dynamic range. The only program I have that uses it is a Mac software program and it’ll turn it on automatically. The reason is for best performance of DXLab Commander. If you can’t find it, set USB SEND to OFF and see if it works for you.
If you’re software has RTS checked off somewhere this will send the radio into TX mode and you’ll usually have to power off the radio and find out what setting in your software has RTS enabled. These settings work for all of my software programs like Ham Radio Deluxe, DXLab Suite, ACLog, N1MM Logger, FLdigi, WSJT-X, JT-Alert, Mac software programs and many more. The above Icom 7610 screen captures are from my Icom 7610.
0 kommentar(er)
